YY9706 Slope for Heating Pad Collision Test

201.9.1.101 heating pad

Heating pad in the picture201.104Test on the slope shown,Slopes are made of artificial boards or other smooth materials.Soft power supply for heating padThe wire is located at a distance from the power input port of the heating pad100mmCut off at the location,Slope and horizontal plane70°Angle

The limit device that can withstand the impact of the heating pad should be fixed at the bottom of the slope.The width of the slope and limit device should be at least equal to the heating of the subjectMaximum size of pad

.The heating pad is placed on a slope,The distance limit device shall not be less than1m(Measure along the slope)position,The lower edge of the heating pad is parallel to the limitdevice.Release the heating pad and let it slide down to impact the limit device100.The four edges of the heating pad should be repeated

The second experiment.after the experiment,If the damage caused results in unacceptable risks as defined in the risk management document,

It is considered as a verification failure.

YY9706.235-2021

• Requirements for Slopes in Section 9.1.101 of the Standard

summary:

• The electric blanket collision testing machine complies with the requirements of Article 21.101 of YY0834-2011 "Special Requirements for Safety of Medical Electric Blankets, Electric Mattresses, and Electric Mattresses" and is used for collision testing of electric blankets.

• Technical features:

• The length and width of the slope can meet the testing requirements for common electric heating pad sizes (please provide the maximum size of the sample);

• The slope forms a 70 degree angle with the horizontal plane;

• The limit device is located at the bottom of the slope;

• Slope and support with stainless steel brackets;

• Material: 304 stainless steel;

Can drive the electric heating pad to continuously impact the limit device;

Equipped with photoelectric sensing port, automatic counting function and 100 prompt function;

Equipment composition:

host device

servo motor

2 sets of sensors

console

Siemens PLC

counter

Rotating shaft, rotating wheel

control module